|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very good quality original datasheet!I like this amazing website!!!!!!
;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
TECH TIPS
Troubleshooting tips and solutions to common service problems
For models: N28, N38, ND310, S26, S38, S310, S312, S412P
Complaint: The port tube in my Northridge series or Studio series loudspeaker is dislodged, loose, or falling out of the cabinet. Probable Cause: A small quantity of some early versions of the above models were manufactured with an inconsistent fit between the port tube and cabinet, resulting in a loose port tube in some cases. Solution: 1) If the port tube is still inserted or partially inserted in the cabinet, remove it by pulling it straight out. Port tube appearance will vary by model. 2) Note the contact area between the port tube and the cabinet. On this area, apply a bead of adhesive; recommended are hot-melt adhesive or silicon sealer. If silicon sealer is used, drying time will be measured in hours, allowing plenty of time to insert and align the port tube properly. CAUTION: with hotmelt adhesive, drying and setting time is measured in seconds, and alignment of the port tube with every model excepting the S38 is critical for proper appearance. 3) Insert the port tube back into the cabinet, noting proper alignment.
TIP# JBLTT2000-02
JBL Incorporated
250 Crossways Park Dr. Woodbury, New York 11797
|
|
|
> |
|